Jeep J-10 Series 1982 Technical & Service Manual page 1105

(b) Install woodgrain inserts.
(6) Install power window bezel, if equipped.
(1) Remove door trim panel.
(2) If equipped with manual window regulator, as
sist handle, or ash receiver:
(a) Cut opening(s) in replacement trim panel,
following outline(s) provided on backside of trim panel,
with sharp knife.
(3) If equipped with power windows, it will be nec
essary to cut opening for switch in replacement trim
panel following outline provided on backside of trim
panel with sharp knife.
(4) Transfer door trim panel attaching clips to re
placement panel.
(5) Install door trim panel.
SEALING SYSTEM
WaterShield
The water shield is attached to the door inner panel
with adhesive. To remove water shield, use a putty knife
between shield and door inner panel to break adhesive
bond.
When installing water shield, be sure the tab on the
lower portion is tucked inside the door panel slit at the
access opening and that the shield is bonded securely to
the door inner panel.
Rubber Sealer
The door rubber sealer is made of molded latex foam
with a smooth rubber skin on the outside.
The rubber sealer is attached to the door body
opening.
Maintenance of RobberSealers
Cold weather may cause the rubber sealer to harden
and lose resiliency. This may cause the door to loosen in
its opening, resulting in noise. When servicing, use a
dampened cloth to clean rubber sealer. Clean dirt from
all points where the rubber sealer contacts the body.
Apply AMC Silicone Lubricant, or equivalent, to sealer.
CAUTION: Do not use graphite, brake fluid or wax on
rubber sealer.
Replacement
Replacement rubber sealers are coated with powder to
prevent stickiness in storage. Before installation, re
move all powder with a cloth dampened with 3M Gen
eral Purpose Adhesive Cleaner, or equivalent.
(1) Carefully remove rubber sealer from door
opening.
DOORS 3J-13
(2) Remove dust and dirt from rubber sealer, door
and body.
(3) Install upper front corner of sealer to door open
ing first.
(4) Complete installation of rubber sealer to re
mainder of door opening.
WINDOW SYSTEM
Door Glass
Removal
(1) Remove door trim panel and water shield.
(2) Remove glass down stop bracket.
(3) Remove division channel lower attaching
bracket.
(4) Lower door glass to obtain access to retainer.
(5) Remove retainer, disengage pin from slot in
channel and lower glass to bottom of door(fig. 3J-5).
(6) Remove inner and outer belt weatherstrips.
(7) Remove upper glass slide channel.
(8) Remove stationary vent assembly attaching
screws (fig. 3J-5).
(9) Tilt top of vent assembly forward approx
imately one inch.
(10) Push lower end of division channel toward rear
of door to release glass.
(11) Move glass toward rear of door to release glass
from front glass slide channel.
(12) Rotate glass 90° and guide glass between inner
and outer door panels.
Installation
(1) Position door glass in lower section of door so
bottom channel has recessed portion toward outer door
panel.
(2) Position door glass in front glass slide channel
and push division channel over glass.
(3) Slide glass up and crank regulator arm down
until pin on regulator arm can be inserted in slot of
bottom channel.
(4) Install retainer.
(5) Position stationary vent assembly and install
attaching screws.
(6) Install upper glass slide channel.
(7) Install inner and outer belt weatherstrip.
(8) Install division channel lower attaching bracket.
(9) Install glass down stop bracket.
(10) Check operation of glass.
(11) Install water shield and door trim panel.