Table of Contents
Advertisement
tcj£>
DETENT
BALL SPRING
AND BOLT
90605
Fig. 2D-10 Detent Ball. Spring and Bolt Removal/Installation
Fig. 2D-11
Oil Pump Removal/Installation
Inspect the condition of all needle, roller, ball and
thrust bearings in the front and rear case halves and the
input gear. Also check the condition of the bearing bores
in both cases and in the input gear, rear output shaft,
side gear, and rear retainer. Replace any part that ex
hibits signs of excessive wear or damage. If the case or
input gear bearings require replacement, refer to Bear
ing Replacement in the Subassembly Overhaul section.
SUBASSEMBLY OVERHAUL
Lockplate Replacement
(1) Remove and discard lockplate attaching bolts.
TRANSFER CASE
2D-13
FRONT OUTPUT SHAFT
REAR THRUST BEARING
ASSEMBLY
Fig. 2D-12 Front Output Shaft Rear Thrust Bearing
Assembly Removal/Installation
DRIVEN
SPROCKET
RETAINING
SNAP RING
sasse
Fig. 2D-13
Driven Sprocket Retaining Snap Ring Removal/Insistri"
(2) Remove lockplate from case.
(3) Coat case and lockplate surfaces around boir
holes with Loctite 515, or equivalent sealant.
(4) Position new lockplate in case and align bol-
holes in lockplate and case.
Advertisement
Table of Contents
Troubleshooting
