Governor Valve Service; Governor Weight E-Clip Location; Governor Valve Assembly - Jeep J-10 Series 1982 Technical & Service Manual

2C-28 AUTOMATIC TRANSMISSION
GOVERNOR VALVE SERVICE
Removal
(1) Raise vehicle.
(2) Mark propeller shaft yokes for assembly align
ment reference.
(3) Disconnect front-rear propeller shafts at trans
fer case.
(4) Disconnect speedometer cable at transfer case.
(5) Place support stand under transmission con
verter housing.
(6) Remove rear crossmember.
(7) Disconnect parking brake cable at equalizer and
disconnect exhaust pipe support brackets, if necessary.
(8) Remove bolts attaching transfer case to trans
mission adapter housing and remove transfer case.
(9) Remove bolts attaching adapter housing to
transmission and remove adapter housing.
(10) Rotate transmission output shaft until governor
weight faces downward (fig. 2C-24).
OUTPUT
SHAFT
GOVERNOR
SUPPORT
(PARK GEAR
GOVERNOR
BODY
OUTPUT
SHAFT
SUPPORT
U..L
Fig. 2C-24 Governor Weight E-Cllp Location
(11) Remove E-clip from weight end of governor
valve shaft (fig. 2C-24).
(12) Remove governor valve and shaft from governor
body (fig. 2C-25).
(13) Remove snap ring that retains governor body-
park gear assembly on output shaft.
(14) Remove governor body-park gear assembly
from output shaft.
SPRING
OUTER WEIGHT
GOVERNOR BODY
VALVE SHAFT
E-CLIP
VALVE
E-CLIP
FILTER SCREEN
60161
Fig. 2C-25 Governor Valve Assembly
Disassembly
(1) Remove large snap ring from weight end of gov
ernor body (fig. 2C-25).
(2) Remove weight assembly.
(3) Remove snap ring from governor weight
assembly.
(4) Separate inner weight, spring, and outer weight.
Identify spring with tag.
(5) If park gear or governor body is to be replaced,
straighten lock tabs and remove bolts attaching body to
gear.
(6) Remove governor filter.
Cleaning and Inspection
Thoroughly clean all governor parts in a suitable
cleaning solution but do not use any type of caustic
cleaning solution.
The weights and valves should fall freely in their
bores when clean and dry. Rough surfaces and burrs
may be polished using crocus cloth.
Inspect the governor weight spring for distortion. Re
place the spring, if damaged.
Clean the filter in solvent and dry it with compressed
air. Replace the filter, if damaged.
Inspect the park gear for chipped or worn gear teeth
or damaged ring grooves. Replace the gear, if damaged.
Check the bolt torque on the output shaft suppor:
attaching bolts. If loose, cross-leakage and loss of gover
nor pressure can occur.
Assembly
(1) If governor body was separated from park gear,
install filter, assemble body and support, and install
attaching bolts finger-tight.
NOTE: Do not tighten the bolts to specified torque
until the assembly is installed on the output shaft.