Power Seats - Jeep J-10 Series 1982 Technical & Service Manual

3M-6 SEAT ASSEMBLIES
SEAT BELT
RETRACTOR
Fig. 3M-7 Rear Folding Seat—Latched Position
70563
Removal
(1) Release latch at lower right side of seat back.
Raise complete seat assembly forward (fig. 3M-8).
(2) Lift complete seat assembly from two floor
mounting hinges.
(3) Remove seat assembly from vehicle.
Installation
(1) Install seat assembly onto hinges.
(2) Position seat back in proper location,.
(3) Secure seat back latch.
Adjustment
(1) Tilt seat back forward and loosen striker bolt to
allow forced movement of striker.
(2) Raise seat back to upright position and tap stri
ker into position for maximum latch/striker
engagement.
(3) Unlatch seat back carefully so as not to change
striker position and tighten striker securely.
(4) Check striker/latch operation.
Fig. 3M-8 Rear Seal Assembly
SEAT BELTS
Removal
(1) Remove seat belt anchor bolt with Torx Bit Tool
J-25359-C.
(2) Remove seat belt.
(3) Obtain access to seat belt retractors by remov
ing rear seat striker (fig. 3M-7) using Torx Bit Tool J-
25359-C.
(4) Remove seat belt retractor.
(5) Inspect seat belt material for evidence of wear,
cuts, or fraying. Replace as required.
Installation
(1) Install seat belt anchor bolt. Tighten to 25 to 35
foot-pounds (34 to 47 N»m) torque.
(2) Position seat belt retractor on wheelhouse and
install rear seat striker using Torx Bit Tool J-25359-C.
(3) Check striker/latch operation.
m
-
POWER SEATS
Page
Adjuster 3M-8
Csble and Housing 3M-8
General 3M-6
Horizontal ind Vertical Transmissions 3M-8
GENERAL
The power seats can be adjusted in six different direc
tions up, down, forward, back, tilt forward, or tilt
rearward.
Page
~
Motor 3M-8
~ Seat Assembly
3M-8
Servicing Procedures
3M-7
~
The control switch is located on the lower outboard
side of the seat. The front lever on the switch (fig. 3M-9)
raises or lowers (tilts) the front of the seat, the center
lever raises or lowers the complete seat by moving the
1