Power Sunroof; Glass Panel - Jeep J-10 Series 1982 Technical & Service Manual

3L-8 HARDTOP ENCLOSURE-SUN ROOF AND LUGGAGE RACKS
POWER SUN ROOF
Pigs
Cable and SideTrack 3L-11
General 3L-8
Gliss Panel 3L-8
Glass Panel Height Adjustment 3L-14
Glass Panel Parallel Alignment 3L-13
Halo Assembly 3L-8
Headlining 3L-12
Manual Operation ofGlass Panel 3L-15
8ENERAL
The power sun roof is available on Cherokee Laredo
and Wagoneer Limited models (fig. 3L-11). The sun roof
features a sliding glass panel operated by an electric
motor and a manually operated sun screen. A nylon knit
1-piece headliner with bond foam backing and a padded
vinyl roof are standard with the optional sun roof.
The electric motor that operates the sliding glass
panel is activated by a two-position switch mounted in
the windshield header. The electric motor itself is
mounted in the forward portion of the sun roof housing
assembly. Electrical feed to the motor is through the
A/C terminal of the fuse panel. Circuit protection is
provided by the A/C terminal fuse and by a 20 amp, in
line fuse in a harness wire located just below the left A-
pillar.
An additional feature of the sun roof is the ability to
close the sliding glass panel manually if an electrical
power failure should occur. A cranking tool is provided
with the sun roof for this purpose.
A rubber drain hose is used at each corner of the sun
roof housing. These hoses remove any water that may
bypass the weatherstrip seal surrounding the roof open
ing. The forward hoses are routed downward through
the A-pillars. The rearward hoses are routed downward
through the D-pillars.
HALO ASSEMBLY
Removal
(1) Open glass panel partially and remove halo as
sembly attaching screws (fig. 3L-12).
(2) Grasp center of halo assembly and pull assem
bly downward to disengage front tabs from track.
(3) Close glass panel fully, slide halo assembly for
ward, and remove assembly from vehicle (fig. 3L-13).
Pagi
Motor Clutch Adjustment 3L-13
Power Son Roof Hooting 3L-11
Power Sun Roof Motor 3L-13
PowerSun RoofSwitch Removal/Installation 3L-13
Sunscreen 3L-10
Vinyl Roof 3L-11
Vinyl Top Repair 3L-15
Installation
(1) Close glass panel and position rear portion of
halo assembly on glass panel.
(2) Open glass panel partially.
(3) Install halo assembly attaching screws and close
glass panel.
GLASS PANEL
Removal
(1) Remove halo assembly. Refer to Halo Assembly
Removal.
(2) Close glass panel and remove outboard screws
from front guide shoe assemblies (fig. 3L-14). Then
loosen inboard screws and rotate guide shoes to dis
engage slide portion from track.
(3) Release rear slide tension springs by rotating
them to inboard position.
(4) Remove screws attaching rear guide shoes and
retainers to tabs in glass panel and remove retainers.
(5) Working from outside of vehicle, raise front of
glass panel and slide panel forward and out of vehicle.
Installation
(1) Position glass panel in vehicle.
(2) Install rear guide shoes and retainer brackets on
glass panel and install guide shoe and retainer bracket
attaching screws.
(3) Install rear slide tension springs (fig. 3L-14).