Table of Contents
Advertisement
36-2
HOODS
INSIDE RELEASE
CABLE
ADJUSTABLE
BUMPER AND
SCREW
SPECIAL
NUT
INSULATION
RELEASE
CABLE SUPPORT
BRACKET
RELEASE
HANDLE
SHIELD
LOCK ASSEMBLY
LEVER
HOOK
SPRING
HINGE
SPRING
HINGE
WASHER
CROSSMEMBER
NUT (LOWER)
426S3
Re. 38-2 Hood and Related Parts—Cnsrokee-Wigonesr-Truck Models
Assembly and Installation
(1) Finger-tighten related component parts and as
semblies to hood panel.
(2) If Cherokee or Wagoneer hood panel insulation
pad has been removed, clean off all loose cement and pad
particles from panel to ensure good adhesion when
recemented.
(3) Position hood panel assembly and align hinges
with scribe marks on respective mounting panels.
Tighten all attaching screws.
(4) Position hood release cable on hood panel brace
rod and attach with tie straps.
(5) Install cable assembly and cable support
bracket. Tighten to 15 foot-pounds (20 N»m) torque.
(6) Attach cable end to lock assembly.
(?) Check hood alignment. Adjust if necessary.
^^\
f-sufsa
«acn\
Advertisement
Table of Contents
Troubleshooting
