Shift Control Housing—T-176 - Jeep J-10 Series 1982 Technical & Service Manual

Table of Contents

MANUAL TRANSMISSION

(6) Install third-fourth shift rail and shift fork as

sembly in transmission case cover.

NOTE: Be sure the interlock pin is in position in the

shift rail before further assembly.

(7.) Install first-second shift rail and fork assembly.

Be sure shift rail notch is over poppet ball in transmis

sion case cover.

(S) Install shifter interlock rings in cover and be

tween poppet balls.

(9) Press downward on shift rails to compress pop

pet balls and springs. Use wood block long enough to

contact all three shift rails to press rails downward

SHIFT LEVER COVER

TRANSMISSION CONTROL

SPRING RETAINER

(10) While holding shift rails downward, position

shift rail retaining plates on housing and install plate

attaching bolts and tabbed washers finger-tight.

(11) Remove wood block and tighten shift rail retain

ing bolts to 12 to 15 foot-pounds (16 to 19 »m) torque.

Be sure tabbed washers are in correct position before

bending washer tabs.

(12) Check shift rail operation. Each rail must slide

smoothly in cover groove. Be sure it is not possible to

overshift into another gear position. After checking

shift operation, place forks in third gear position.

(13) Install shift lever, spring, spring retainer and

control housing cap (fig. 1). Push cap downward and

turn lever retainer clockwise to install and seat.

FULCRUM PIN (2)

TRANSMISSION

REVERSE ROCKER

ARM ASSEMBLY

REVERSE SHIFT

REVERSE FORK

Fig. 2B-68 Shift Control Housing—T-176

Troubleshooting