Jeep J-10 Series 1982 Technical & Service Manual page 1174

3R-10 UGHTING SYSTEMS
ROCKER
SWITCH
FRESH AIR
VENT
Rg. 3R-15 Switch Location—Typical
(a) Horizontal distance between light beams on
wall should be same size as distance between lamps on
front bumper.
BODY
(b) Vertical height of light beams on wall
should be 4 inches less than height of lamps on front
bumper.
(4) Tighten lamp attaching hardware.
(5) Turn off headlampand foglamp switches.
(6) Install lamp stone shields.
Lamp Element Raplacamrat
(1) Remove lampstoneshields (fig. 3R-16).
(2) Remove screws attaching bezel to lamp body.
Remove bezel from lamp body.
(3) Remove lens and reflector assembly from lamp
body.
(4) Remove bulb holder from lens and reflector
assembly.
(5) Remove lamp element from bulb holder and in
stall replacement lamp element.
(6) Install bulb holder in lens and reflector
assembly.
(7) Position lens and reflector assembly in lamp
body with TOP of lens at top of lamp body.
STONE SHIELD
LENS & REFLECTOR
Fig. 3R-16 Fog Lamp Components
80635