Disassembly—Output Shaft Geartrain; Transmission Cover Removal/Installation; Reverse Lever And Pivot Bolt; Reverse Lever C-Clip Removal/Installation - Jeep J-10 Series 1982 Technical & Service Manual

(18) Remove reverse idler shaft roll pin using ham
mer and pin punch (fig. 2B-19).
(19) Remove reverse idler shaft and gear (fig. 2B-19).
Note position of gear for assembly reference.
(20) Remove countershaft front bearing using arbor
press.
(21) Remove clutch shaft front bearing using Bear
ing Removal Tool J-29721 and J-22912 (fig. 2B-20).
(22) Remove rear adapter housing seal using flat
drift and hammer.
Fig. 2B-9 Transmission Cover Removal/Installation
* 1... . :.|
81199N
Fig. 2B-10 Reverse Lever C-Clip Removal/Installation
MANUAL TRANSMISSION 2B-9
(23) Remove backup lamp switch from transmission
case.
Disassembly—Output Shaft Geartrain
(1) Remove thrust bearing washer from front end
of output shaft.
(2) Scribe alignment marks on third-fourth syn
chronizer hub and sleeve for assembly reference (fig. 2B-
21).
fer pivot
BOLT
Fig. 2B-11 Reverse Lever and Pivot Bolt
FRONT
BEARING
CAP
FRONT
SHIM BEARING
RACE
81200B
81199C
Fig. 2B-12 Front Bearing Cap. Shim and Race Removal/Installation
/