Front Clutch Assembly—Model 727; Front Clutch Retainer Bushing Removal—Model 727 - Jeep J-10 Series 1982 Technical & Service Manual

2C-52 AUTOMATIC TRANSMISSION
PISTON
RETAINER ASSEMBLY
PISTON
SEAL (INNER
I
SNAP RING
(WAVED)
PRESSURE PLATE
90539
Fig. 2C-72 Front Clutch Assembly—Model 727
TOOL
J-24042
0*1 -
41834
Fig. 2C-73 Front Clutch Spring Retainer
Removal/Installation—Model 727
(6) Install Compressor Tool J-24042 over retainer
assembly.
(7) Compress springs and seat snap ring in hub
groove.
(8) Remove compressor tool.
(9) Lubricate clutch plates with transmission fluid.
(10) Install one steel plate followed by one lined plate
until correct number of plates are installed.
(11) Install pressure plate and waved snap ring.
Measure clutch pack clearance using feeler gauge (fig.
2C-71). Refer to clutch plate clearance in Specifications
section for tolerances.
TOOL
J-8092
TOOL
J-24039
41835
Fig. 2C-74 Front Clutch Retainer Bushing Removal—Model 727
(12) If clutch pack clearance is not within specifica
tions, disassemble clutch pack and measure thickness of
lined plates, steel plates, and pressure plate. Thickness
should be as follows:
*
-
—
—