Section Index - Jeep J-10 Series 1982 Technical & Service Manual

3J-1
DOORS
Page
Chirokei-Wigoneer Rear Doors 3J-12
ChirokN-WagonMr-Truck Front Doors 3J-5
CJ-7 and Scrambler With Hardtop Enclosure 3J-1
SECTION INDEX
Page
Power Door Locks 3J-21
Electrically Operated Windows 3J-16
Tools 3J-22
CI-7 AND SCRAMBLER
WITH HARDTOP ENCLOSURE
DOOR TRIM
Page
Door Trim 3J-1
Hinge System 3J-5
Lock System 3J-4
Window Regulator Handle
Window regulator handles are attached to the splined
shaft of the window regulator with a 5/32-inch Allen
head screw. To remove the handle, remove the screw and
pull the handle straight off the shaft.
Install the handle with the knob forward, the handle
horizontal and the glass all the way up.
Door Assist Handle
Removal
(1) Remove screws attaching door assist handle
using Torx Bit Tool J-25359-C.
(2) Remove handle from door.
Installation
(1) Position handle on door.
(2) Install attaching screws using Torx Bit Tool
J-25359-C.
Trim Panel
Trim panels consist of fiber board composition cov
ered with a vinyl material. They are fastened to the door
Sealing System
Window System
Page
3J-1
3J-2
with plastic clips inserted into holes in the door inner
panel.
Removal
(1) Remove door assist handle.
(2) Remove window regulator handle.
(3) Pry trim panel-to-door clips along sides loose
with Trim Pad Depressor Tool J-2631-01 and remove
panel.
Installation
(1) Position trim panel on door and install clips in
holes in inner door panel.
NOTE: To prevent creasing the trim panel cover, do
not hammer or exert excessive force on the clips.
(2) Install window regulator handle.
(3) Install door assist handle.
SEALING SYSTEM
Water Shield
The water shield is attached to the door inner panel
with adhesive. To remove water shield, use a putty knife