Offset Lever Pin Removal; Offset Lever Spring And Ball; Offset Lover Removal/Installation - Jeep J-10 Series 1982 Technical & Service Manual

2B-8 MANUAL TRANSMISSION
(11) Rotate clutch shaft until flat on gear teeth is
facing countershaft and remove shaft (fig. 2B-13).
(12) Remove thrust bearing and 15 roller bearings
from clutch shaft (fig. 2B-14).
(13) Remove output shaft bearing race (fig. 2B-15).
Tap front of output shaft with rubber or plastic mallet,
if necessary.
(14) Tilt output shaft assembly upward and remove
from transmission case (fig. 2B-16).
81198B
Fig. 2B-5 Offset Lever Pin Removal
"ft, n>
81198C
Fig. 2B-6 Offset Lover Removal/Installation
(15) Remove countershaft rear bearing using brass
drift and arbor press (fig. 2B-17). Note position of bear
ing for assembly reference. Bearing identification num
bers face outward when bearing is correctly installed.
(16) Move countershaft rearward, tilt shaft upward
and remove shaft from case. Remove countershaft front
thrust washer from case, noting position of washer for
assembly reference.
(17) Remove countershaft rear bearing spacer (fig.
2B-18).
SPRING
OFFSET
LEVER
Fig. 2B-7 Offset Lever Spring and Ball
Fig. 2B-8 Countershaft Rear Thrust Bearing and
Race Removal/Installation
81198D
81196G