Rear Band And Drum; Rear Servo - Jeep J-10 Series 1982 Technical & Service Manual

2C-36 AUTOMATIC TRANSMISSION
CAUTION: Be very careful to protect the machined
surfaces on the output shaft during removal
Rear Band and Drum
(1) Pull drum forward and out of case.
(2) Loosen band adjusting screw.
(3) Thread 1/4-inch (6 mm) bolt into actuating lever
pivot pin.
(4) Grip bolt with pliers and remove pivot pin.
(5) Remove lever, linkage and band.
Overrunning Clutch
Carefully remove clutch hub, rollers and springs, and
store parts where they will not be lost or damaged.
Front Servo
(1) Remove front servo pressure port plug.
(2) Compress servo piston rod guide until it bottoms
in case bore.
(3) Insert No. 2 Phillips screwdriver into pressure
port (fig. 2C-39).
60164
Fig. 2C-39 Front Servo Removal
(4) Slowly release rod guide against screwdriver
(fig. 2C-39).
(5) Remove servo retaining snap ring.
(6) Compress rod guide and remove screwdriver.
(7) Slowly release rod guide and remove rod guide,
springs and piston rod.
CAUTION: Do not grasp the rod with pliers to remove
it. If the rod sticks in the case, tap it gently to release it.
(8) Identify servo springs) with tag(s) for assembly
reference.
(9) Remove servo piston.
-'-''*•',.• • »•• . . '
Rear Servo , - ;
•" (1) Compress piston spring and remove snap ring
(fig.2C-40). -••": : v • '.
(2) Remove spring retainer, spring, piston and plug
assembly. 'Identify spring- with tag for assembly
reference. V:
60165
Rg. 2C-40 Rear Servo Spring and Soap Ring Removal
SUBASSEMBLY OVERHAUL
Valve Body
Disassembly
CAUTION: Do not clamp any part of the valve body or
transfer plate in a vise. Any slight distortion ofthe body
or plate will cause sticking valves or excessive leakage or
both. When removing and installing valves or plugs,
slide them in or out very carefully. Do not use force to
remove or ins tall valves.
(1) Mount valve body on Repair Stand Tool J-24043.
NOTE: When disassembling the valve body, identify
all valve springs with a tag for assembly reference.