Oil Filter Removal - Jeep J-10 Series 1982 Technical & Service Manual

(2) Remove oil filter attaching screws and oil filter
(fig. 2C-41).
NOTE: Oil filter screws are longer than transfer plate
screws.
(3) Remove screws attaching lockup module to
valve body (fig. 2C-42).
(4) Slide lockup module oil tube out of valve body
and remove tube and module as an assembly.
(5) Remove end plate from module.
(6) Remove lockup valve and spring.
(7) Remove fail-safe valve and spring.
41800
Fig. 2C-41 Oil Filter Removal
TUBE
AUTOMATIC TRANSMISSION 2C-37
NOTE: Tag springs and valves for reassembly
reference.
(8) Remove upper and lower screws from spring
retainer and adjustment screw bracket (fig. 2C-43). Hold
spring retainer firmly against spring force while remov
ing last screw.
(9) Remove spring retainer, line and throttle pres
sure adjusting screws. Do not disturb screw settings.
Remove line pressure and torque converter valve regu
lator springs. Tag springs for assembly reference.
(10) Remove line pressure regulator and torque con
verter control valves (fig. 2C-43).
(11) Remove transfer plate assembly retaining
screws and remove transfer plate assembly.
(12) Remove screws attaching separator plate to
transfer plate and separate these parts (fig. 2C-44).
(13) Remove rear clutch check ball from transfer
plate and remove pressure regulator valve screen from
separator plate.
(14) Remove check balls and spring from valve body
(fig. 2C-45). Tag spring for assembly identification.
(15) Turn valve body over and remove shuttle valve
cover plate (fig. 2C-46).
(16) Remove governor plug end plate (fig. 2C-47),
shuttle valve throttle plug and spring, and 1-2 and 2-3
shift valve governor plugs.
(17) Remove shuttle valve E-clip, shuttle valve sec
ondary spring, spring guides, and shuttle valve.
(18) Install Detent Ball Retainer ToolJ-24044 around
detent ball casing (fig. 2C-48).
LOCK-UP MODULE
FAILSAFE SPRING
FAIL-SAFE VALVE
LOCK-UP VALVE
LOCK-UP SPRING J7 Qj
SCREW (2)
END PLATE
%
90533
Rg. 2C-42 Lockup Module—Models 999/727