Jeep J-10 Series 1982 Technical & Service Manual page 867

fi$$\
STEERING COLUMNS 2J-9
Service Diagnosis — Turn Signal (Continued)
Condition Possible Cause
Correction
TURN SIGNAL
LIGHTS FLASH
VERY SLOWLY
(CONT.)
(4)
Loose chassis to column harness
connection.
(4)
Connect securely.
(5) Disconnect column to chassis
connector. Connect new switch
into system without removing
old. Operate switch by hand.
If flashing occurs at normal rate,
the signal switch is defective.
(5)
Replace turn signal switch.
HAZARD SIGNAL
LIGHTS WILL NOT
FLASH-TURN
SIGNAL FUNCTIONS
NORMALLY
(1)
(2)
Blown fuse.
Inoperative hazard warning
flasher.
(1)
(2)
Replace fuse.
Replace hazard warning
flasher in fuse panel.
(3) Loose chassis-to-column
harness connection.
(3)
Connect securely.
(4) Disconnect column to chassis
connector. Connect new switch
into system without removing
old. Depress the hazard warning
lights. If they now work
normally, turn signal switch
is defective.
(4)
Replace turn signal switch.
•
(5)
If lights do not flash, check
wiring harness "K" lead for open
between hazard flasher and
connector. If open, fuse block
is defective.
(5)
Repair or replace brown wire
or connector as required.
60659K