Jeep J-10 Series 1982 Technical & Service Manual page 1069

(2) Remove nuts, washers, bolts and nut plates (fig.
3F-27) attaching roll bar to side of pickup box, using
Torx Bit Tool J-25359-C.
ROLL BAR
ANTI-SQUEAK
NUT PLATE
80442
Rg. 3F-27 Roil Bar—Townsids Track
(3) Remove nuts, washers and bolts attaching roll
bar to bed of pickup box, using Torx Bit Tool J-25359-G.
(4) Remove roll bar assembly and anti-squeak ma
terial from pickup box.
Installation
(1) Position anti-squeak material and roll bar as
sembly on pickup box.
(2) Install bolts, washers and nuts attaching roll
bar to bed of pickup box, using Torx Bit Tool J-25359-G.
NOTE: Do not tighten attaching hardware until roll
bar is completely installed and properly aligned;
(3) Install bolts, washers, nuts and nut plates at
taching roll bar to side of pickup box.
(4) Align roll bar assembly and tighten all attach
ing hardware using Torx Bit Tool J-25359-G.
(5) Install CB radio antenna on roll bar, if equipped.
BODY AND FRAME COMPONENTS 3F-19
SPORT TRUCK
Removal
(1) Remove GB radio antenna from roll bar, if
equipped.
(2) Remove wooden side rails, if equipped.
(3) Remove nuts, washers and bolts attaching roll
bar to bed of pickup box, using Torx Bit Tool J-25359-G
(fig. 3F-28).
ROLL BAR
Rg. 3F-28 Ron Bar—Sport Track
(4) Remove roll bar assembly from pickup box.
Installation
(1) Position roll bar on bed of pickup box.
(2) Install bolts, washers and nuts attaching roll
bar to bed of pickup box using Torx Bit Tool J-25359-G.
NOTE: Do not tighten attaching hardware until roll bar
is completely installed and properly aligned.
(3) Align roll bar assembly and tighten all attach
ing hardware using Torx Bit Tool J-25359-G.
(4) Install wooden side rails, if equipped.
(5) Install GB radio antenna on roll bar, if equipped.
90990
BRUSH GUARDS
CHEROKEE-TRUCK MODELS
Removal
(1) Disconnect and remove fog lamps, if equipped.
(2) Remove bolts and washers attaching brush
guard (fig. 3F-29) to frame rails.
(3) Remove nuts and bolts attaching brush guard to
bumper bolts and remove brush guard.
Installation
(1) Position brush guard on bumper and install at
taching bolts and nuts.