In-Vehicle Service And Adjustment; Gearshift Linkage Adjustment; Front Band Adjustment - Jeep J-10 Series 1982 Technical & Service Manual

AUTOMATIC TRANSMISSION 2C-25
IN-VEHICLE SERVICE
AND ADJUSTMENT
Fluid Level Check
Front Bind Adjustment
Gearshift Linkage Adjustment
Governor Valve Service
Neutral Start and Backup Lamp Switch
Oil Filter Replacement
Page
2C-32
2C-25
2C-25
2C-28
2C-29
2C-26
GEARSHIFT LINKAGE ADJUSTMENT
(1) Raise vehicle.
(2) Loosen shift rod trunnion jamnuts.
(3) Remove lockpin retaining shift rod trunnion to
bellcrank and disengage trunnion and shift rod at bell
crank
(4) Place gearshift lever in Park position and lock
steering column.
(5) Move valve body manual lever rearward into
Park detent. Be sure lever is moved rearward as far as
possible. Park detent is last rearward detent.
(6) Check for positive engagement of park lock by
attempting to rotate propeller shaft. Shaft will not ro
tate if park lock pawl is fully engaged in park gear.
(7) Adjust shift rod trunnion to obtain free pin fit in
bellcrank arm and tighten trunnion jamnuts. Prevent
shift rod from turning while tightening jamnuts.
NOTE: Gearshift linkage lash must be eliminated in
order to obtain a proper adjustment. Eliminate lash by
pulling downward on the shift rod and pressing upward
on the outer bellcrank.
(8) Move gearshift lever to Park and Neutral posi
tions and check engine starting. Engine should start in
these positions only. Engine must not start in any gear
position other than Park or Neutral. If engine does not
start or starts in R, D, 2, or 1, adjustment is incorrect or
neutral switch is defective.
(9) Check steering lock for ease of operation.
(10) Lower vehicle.
FRONT BAND ADJUSTMENT
The front band adjusting screw is located on the left
side of the transmission case just above the manual
valve and throttle control levers (fig. 2C-19).
Adjustment Procedure
(1) Raise vehicle.
(2) Loosen adjusting screw locknut and back off
locknut five turns.
(3) Check adjusting screw rotation. Screw must
turn freely in case. Lubricate adjusting screw threads if
screw binds.
Park Lock Component Replacement
Rear Band Adjustment
Specifications
Throttle Linkage Adjustment
Valve Body Service
Fig. 2C-19 Front Band Adjustment
(4) Tighten adjusting screw to 36 inch-pounds (4
N«m) torque using Torque Wrench J-5S53, Adapter Tool
J-24063 and 5/16 square socket (fig. 2C-19).
CAUTION: If Adapter Tool J-2^063 is not used, the
band adjusting screw must be tightened to 72 inch-
pounds (8 X9m) torque.
(5) Back off adjusting screw 2-1/2 turns.
(6) Tighten adjuster screw locknut to 35 foot
pounds (47 N*m) torque. Do not allow adjuster screw to
rotate when tightening locknut.
(7) Lower vehicle.
Page
2C-29
2C-26
2C-32
2C-30
2C-26