Disassembly Mainshaft Geartrain; Clutch Shaft Front Bearing Removal; Removing Front Bearing From Clutch Shaft - Jeep J-10 Series 1982 Technical & Service Manual

2B-28 MANUAL TRANSMISSION
J-29344
PULLER SET
J-25152
90626
Fig. 2B-55 Clutch Shaft Front Bearing Removal
PULLER SET
J-25152
J-29344
90623
Fig. 2B-56 Removing Front Bearing from Clutch Shaft
(19) Remove needle bearings and bearing retainers
from gear assembly (fig. 2B-58). Remove sliding gear
from idler gear. Note position of sliding gear for assem
bly reference.
(20) Remove arbor tool from countershaft gear and
remove needle bearings and bearing retainers (fig. 2B-
59).
Disassembly Mainshaft Geartrain
(1) Remove third-fourth synchronizer snap ring
from front end of mainshaft (fig. 2B-60).
I REVERSE — . •
IDLER GEAR SHAFT .
90629
Fig. 2B-57 Reverse Idler Gear Shaft Removal/Installation
REVERSE IDLER
GEAR SHAFT
BEARING
RETAINER
REVERSE IDLER GEAR
NEEDLE
BEARINGS (44)
SLIDING
GEAR
BEARING
RETAINER
90630
Fig. 2B-58 Reverse Idler Gear Assembly