Throttle Linkage Adjustment—-Eight-Cylinder Engine - Jeep J-10 Series 1982 Technical & Service Manual

(3) Use throttle control rod spring to hold transmis
sion throttle control lever forward against stop (fig. 2C-
30). Hook one end of spring on throttle control lever and
other end on throttle linage bellcrank bracket attached
to converter housing.
41320 •
Fig. 2C-30 Installing Throttle Control Lever Spring—
Six-Cylinder Engine
(4) Block choke open and set carburetor throttle off
fast idle cam.
NOTE: On carburetors equipped with a throttle oper
ated solenoid valve, turn the ignition lock to the ON
position to energize the solenoid. Then open the throttle
halfway to allow the solenoid to lock and return the
carburetor to idle position.
(5) Loosen retaining bolt on throttle control adjust
ing link. Do not remove spring clip and nylon washer.
* (6) Pull on end of link to eliminate lash and tighten
link retaining bolt (fig. 2C-31).
(7) Remove throttle control rod spring from linkage
and install it on control rod.
(8) Lower vehicle.
Throttle Linkage Adjustment—-Eight-Cylinder Engine
(1) Disconnect throttle control rod spring at
carburetor.
(2) Raise vehicle.
(3) Use throttle control rod spring to hold transmis
sion throttle valve control lever forward against stop.
(4) Block choke open and set carburetor throttle off
fast idle cam.
AUTOMATIC TRANSMISSION 2C-31
NOTE: On carburetors equipped with throttle operated
solenoid valve, turn ignition lock to ON position to ener
gize solenoid. Then open throttle halfway to allow sole
noid to lock and return carburetor to idle position.
BELLCRANK
THROTTLE
CONTROL
ROD SPRING
THROTTLE
CONTROL
ROD
THROTTLE CONTROL
ROD SPRING HITCH PIN
81175
Fig. 2C-31 Throttle Control Assembly—Six-Cylinder Engine
(5) Loosen retaining bolt on throttle control rod ad
justing link. Remove spring clip and move nylon washer
to rear of link.
(6) Push on end of link to eliminate lash and tighten
link retaining bolt (fig. 2C-32).
(7) Install nylon washer and spring clip (fig. 2C-33).
(8) Remove throttle control rod spring from linkage
and install it on rod.
(9) Lower vehicle.
Fig. 2C-32 Tightening Link Retaining Bolt—
Eight-Cylinder Engine