Jeep J-10 Series 1982 Technical & Service Manual page 1124

3L-6 HARDTOP ENCLOSURE-SUN ROOF AND LUGGAGE RACKS
(10) Empty spray gun and fill cup with reducer.
(11) Spray reducer on edges of painted area to elimi
nate overspray and blend in repair.
(12) Bake for 30 minutes at temperature not to ex
ceed 140°F or let air dry for 24 hours.
(13) Clean spray equipment thoroughly.
NOTE: Equipment must be cleaned immediately after
use.
MANUALLY OPERATED
SUN ROOF
fw%\
Cherokit-Wigonetr
CJ Models
Pifli
3L-7
3L-6
GENERAL
A manually operated sun roof as shown in figure 3L-9
is available on CJ models equipped with the hardtop
option. The sun roof can be opened and locked in place or
removed entirely. To remove the sun roof glass, pull the
retaining rod and disconnect the latch handle assembly.
Tilt the glass to an angle greater than 60 degrees, release
bayonets from retainers, and remove glass. Safely stow
the glass in storage compartment.
CLAMP RING
COVER
90190A
Rg. 3L-9 Sun Root Component—CJ Models with Htrdtop
CJ MODELS
Page
Geoiral 3L-6
Sun Roof Glass
The bayonets and handle assembly are retained by
screws with circular water seals, and retaining nuts
with washers.
Frame
Removal **>
(1) Remove glass assembly. /m>
(2) Remove frame screw cover. ^
(3) Remove attaching screws from clamp ring.
(4) Removeclampring. ***
(5) Push frame assembly outward and remove ^
frame.
Installation ^
(1) Clean sun roof frame and roof panel contact
surfaces using 3M General Purpose Adhesive Cleaner
and Wax Remover, or equivalent.
(2) Apply bead of 3M Clear Super Silicone Sealer, or
equivalent, on surface of outer roof panel, 1/8 inch from
edge of opening.
(3) Install sun roof frame in roof panel.
(4) Position clamp ring over sun roof frame.
(5) Install attaching screws.
(6) Wipe excessive sealer from roof panel.
(7) Install screw cover.
(8) Install glass assembly.
Glass Frame Weatherseal
To remove the glass frame weatherseal use a 3M Re
lease Agent, or equivalent. Apply one application and
jf35>