Table of Contents
Advertisement
WINDSHIELD WIPERS
3T-19
TAG WIRE
(18) Install grommets in mounting bracket and se
cure motor assembly to bracket with attaching screws.
Tighten attaching screws to 23 inch-pounds (3 N»m)
torque.
(19) Install plain washer and spring washer on out
put shaft, position drive crank on output shaft in the
marked position from which it was removed, and install
nut. Tighten nut to 120 inch-pounds (14 N«m) torque.
Rg.3T-18 Tig Win Brush Rotilnirs
80490
WINDSHIELD WASHERS
The electric pump assembly is mounted in the bottom
of the water reservoir. The impeller motor case is
grounded to the car body by a ground wire. It is ener
gized by a feed wire from the number 6 and 7 terminals
on the control switch.
SPECIFICATIONS
Torque Specifications
Service Sot-To Torques should be used whan assembling components. Service In-Use Recheck Torques should be used for checking s pre-tightened Item.
Wiper Motor MTG. Plate to Cowl-
Windfhield Wiper Pivot to Cowl—
USA (in
•lbs)
Metric
(N-m)
Service
In-Use
Service
In-Use
Set-To
Recheck
Set-To
Recheck
Torque
Torque
Torquo
Torque
23
15-35
3
2-4
118
100-135
13
11-15
All Torque values given in newton-meters and inch-pounds with dry fits unless otherwise specified.
70269
WIPER ARM
REMOVAL TOOL
J-22128
J-21008
CONTINUITY LIGHT
Toole
J-2S359-C
TORX BIT AND
SOCKET SET
giHBai
I :7>~ «
c.:.>-
701 '>r'
Advertisement
Table of Contents
Troubleshooting
