Table of Contents
Advertisement
3F-8 BODY AND FRAME COMPONENTS
REAR QUARTER PANELS
The rear quarter panels are welded to the body as
indicated in figures 3F-6 through 3F-9.
80171F
Rg. 3F-6 Rear Quarter Panel—CJ Models
77^
Rg. 3F-7 Rear Quarter Panel—Scrambler Models
80171G
Whenever a rear quarter panel is replaced, it is very
<=*»
important to apply a suitable corrosion preventive such
_
as a weld primer to all mating surfaces prior to welding.
80171H
Rg. 3F-8 Rear Quarter Panel—2-Door Cherokee
80171J
Rg. 3F-9 Rear Quarter Panel—Wagoneer (4-0oor Cherokee Similar)
^
RADIATOR GRILLES
Paga
CJ and Scrambler Models
3F-8
Cherokee-Truck Models
3F-9
CJ AND SCRAMBLER MODELS
The CJ and Scrambler grille, support and the baffle
are welded together to form a maximum-strength radi
ator grille guard (fig. 3F-10).
Removal
(1) Remove front crossmember cover, if equipped.
(2) Remove screws and washers attaching radiator
and shroud to radiator grille guard panel.
(3) Remove bolts and washers attaching guard
panel to fenders.
Grille Applique—CJ and Scrambler Models
Wagoneer Models
Paga
3F-9
3F-10
(4) Remove radiator grille to frame crossmember
holddown assembly. Note sequence of parts removal.
(5) Loosen nuts attaching two radiator support rods
to radiator grille guard support brackets.
(6) Remove rods from brackets.
(7) Tilt grille panel forward and disconnect elec
trical wiring at head lamp sealed beam unit and parking
lamp assembly wiring harness at connectors.
(8) If equipped with air conditioning, proceed as
follows:
(a) Discharge air conditioning system as out
lined in Chapter 3E—Air Conditioning.
Advertisement
Table of Contents
Troubleshooting
