Pump Bushing Removal—Model 727; Reaction Shaft Bushing Removal—Model 727; Pump Bushing Installation—Model 727 - Jeep J-10 Series 1982 Technical & Service Manual

2C-48 AUTOMATIC TRANSMISSION
TOOL
J-8092
TOOL
J-24055
41826
Fig. 2C-63 Pump Bushing Removal—Model 727
.41827
Fig. 2C-64 Pump Bushing Installation—Model 727
CAUTION: Do not chimp any part of the reaction
shaft or support in a vise.
(8) Thread Bushing Remover Tool J-24037 into
bushing as far as possible by hand (fig. 2C-65).
(9) Using wrench, thread remover tool into bushing
SLIDE
HAMMER
J-6585-1
BUSHING REMOVER
TOOL J-24037
SLIDE HAMMER
SCREW J-7004-3
41828
Fig. 2C-65 Reaction Shaft Bushing Removal—Model 727
three to four additional turns to fully engage threads of
tool in bushing.
(10) Install Slide Hammer Bolts Tool J-7004-3 and J-
6585-1 into remover tool (fig. 2C-65). Bump outward
with slide hammers to remove bushing.
(11) Thoroughly clean reaction shaft support assem
bly after bushing removal.
(12) Grip old bushing with pliers and remove it from
Tool J-24037.
NOTE: Be sure to protect the threads on the remover
tool when using the tool.
(13) Thread Bushing Installer Tool J-24038 onto
Driver Handle J-8092 (fig. 2C-66).
(14) Position replacement bushing on installer tool
and install bushing straight into shaft bore until tool
bottoms.
Assembly
(1) Install pump rotors in housing.
(2) Install reaction shaft support and tighten at
taching bolts to 160 inch-pounds (18 N»m) torque.
(3) Install O-ring seal around pump housing flange.