Jeep J-10 Series 1982 Technical & Service Manual page 1155

3P-1
HEADLINING-
TERIOR DECALS
AND OVERLAYS
SECTION INDEX
Page
Exterior Decais 3P-2
Exterior Woodgraln Overlays 3P-6
Page
Headlining 3P-1
Tools 3P-9
HEADLINING
CJ-7 Limited
Cherokee-Wagoneer Models
Psge
3P-1
3P-1
GENERAL
The headlining used in CJ-7 Limited, Cherokee,
Wagoneer and Truck models is made of laminated poly
styrene backing board which is finished, depending on
the model, with either a plastic coating, or a close knit
fabric. Lines pressed into the backing board allow the
headlining to be shaped to fit the contour of the roof
while providing added strength for self-support.
NOTE: Information regarding the headliner used with
the Wagoneer Limited power sun roof can be found in
Chapter 3L.
CJ-7 LIMITED
Removal
(1) Remove moulded top as outlined in Chapter 3L.
(2) Remove dome lamp from top.
(3) Remove right and left side mouldings.
(4) Remove headlining retainer screws.
(5) Manuever headlining out of front and rear
mouldings and remove headlining.
Installation
(1) Position headlining into front and rear
mouldings.
(2) Install retaining screws on right and left side.
Page
General 3P-1
Truck Models 3P-2
(3) Install side mouldings.
(4) Install dome lamp assembly.
(5) Install top on vehicle as outlined in Chapter 3L.
CHEROKEE-WAGONEER MODELS
Removal
(1) Remove sun visors, escutcheons and center
support.
(2) Remove windshield moulding and end caps.
(3) Remove rear opening moulding and end caps.
(4) Remove plastic trim center moulding and end
cap retainers.
(5) Remove lens from dome lamp and cargo lamp.
Remove screws attaching lamp to roof bows. Remove
and disconnect cargo lamp switch.
(6 ) Remove coat hooks.
(7) If equipped with inside spare tire, proceed as
follows:
(a) Remove inside spare tire.
(b) Remove upper bracket shoulder screw, us
ing Torx Bit Tool J-25359-C.
(8) Free rear headlining from J-moulding by pulling
down carefully at center, while pushing up on either
outside edge.
(9) Push cargo lamp through die-cut opening in
headlining.
I