Wheelhouse Carpet - Jeep J-10 Series 1982 Technical & Service Manual

SEAT ASSEMBLIES 3M-9
CARPETING
Page Page
Floor Carpet 3M-9
Front Floor Carpet 3M-9
Rear Compartment Carpet 3M-9
Wheelhouse Carpet 3M-9
FLOOR CARPET
The rear floor carpet is held in position by the seats,
center console, seat belts, sill plates and other
components.
When removing and installing the rear floor carpet it
may be necessary to remove and install the above items.
FRONT FLOOR CARPET
On Wagoneer, Cherokee, and Truck models the front
floor carpet is held in position by the seats, seat belts,
sill plates and other components. On CJ and Scrambler
models the front floor carpet is held in position by velcro
strips. The CJ-7 Limited model front floor carpet is
glued into position.
When removing and installing the carpet, it will also
be necessary to remove and install the above items also.
When replacing the front floor carpet, position the
carpet in the vehicle and cut the openings in the carpet
using a sharp knife or razor blade for such things as the
floor shifter, if equipped.
REAR COMPARTMENT CARPET
The rear compartment carpet is fitted to the rear
compartment and is held in position by the skid strip
screws and rear seat. On CJ models the rear com
partment carpet is held in position with glue and velcro
strips.
The replacement carpet may require some modifica
tions to accommodate these items.
WHEELHOUSE CARPET
The wheelhouse carpet is held in place by a com
bination of the trim panel and adhesive on the senior
line vehicles.
When installing the wheelhouse carpet on the senior
line vehicles apply 3M General Trim Adhesive, or equiv
alent to the backside of carpet before installing.
On CJ models the wheelhouse carpet is held in posi
tion by glue and velcro strips.
Tools
J-25359-C TORX BIT AND SOCKET SET
70119