Specifications - Jeep J-10 Series 1982 Technical & Service Manual

TRANSFER CASE 2D-37
SPECIFICATIONS
Specifications—Model 219 Quadra-Trac Transfer Case
Transfer Case Type 4 position, dual range,
full time 4-wheel drive
unit with integral low
range and a neutral and
lock position
Torque Transmittal Mode Dual sprockets with
connecting drive chain and
an interaxle differential — viscous
coupling unit
Low Range Reduction
Ratio and Mode . . .2.61:1 through annulus
gear and planetary carrier
assembly
Drive Positions and
Shift Controls . . .
Lubricant Capacity
and Type
4H.4L. Neutral, Lock.
Ranges selected via floor mounted
shift lever (4H range is fully
differentiated. 4L and Lock
ranges are undifferentiated
4 pints (1.9 liters) Jeep.
Dextron II Automatic
transmission fluid only.
90769
Torque Specifications
Service Set-To Torques should be used when assembling components. Service In-Use Recheck Torques should be used for checking e pre-tightened Item.
USA (ft-lbs) Metric (Nm)
Detent Retainer Bolt
Drain and Fill Plugs
Front/Rear Yoke Nuts
Indicator Switch
Operating Lever Locknut
Rear Case-to-Front Case Bolts (All)
Rear Retainer Bolts
Service Service
Service
In-Use Service
In-Use
Set-To Recheck
Set-To Recheck
Torque Torque Torque
Torque
23 20-25 31
27-34
35 30-JO
47
40-54
120
90-130 163 122-176
18 15-20
24 20-34
18 14-20
24 19-27
23 20-25 31
27-34
23 20-25 31
27-34
tecified.
90620
All torque values given in foot-pounds and newton-meters with dry fits unless otherwise specified
MODEL 300 TRANSFER CASE
Page
Assembly
Cleaning and Inspection
Disassembly
General
20-45
20-44
20-41
20-37
Identification
2D-38
GENERAL
The model 300 transfer case is used in CJ and Scram
bler models only. It is a gearbox unit having the gears
positioned in a layshaft-type of arrangement. The 300
has a cast iron case, four gear positions and employs an
external floor mounted gearshift linkage for range con
In-Vehicle Service 2D-38
Lubrication
20-38
Power Row 20-38
Service Diagnosis
20-38
Specifications
2D-47
trol. The 300 is a part-time four-wheel drive unit provid
ing four-wheel high and low ranges, a neutral position
and two-wheel high range. The four-wheel high and low
ranges are undifferentiated. Manual locking front hubs
are standard equipment with this transfer case. In addi
tion, the 300 is used with both manual and automatic