Jeep J-10 Series 1982 Technical & Service Manual page 628

Table of Contents

Fig. 2C-55 Staking Oil Pump Bushing

Fig. 2C-56 Reaction Shaft Bushing Removal—Model 999

(9) Clean reaction shaft support thoroughly after

bushing installation.

(1) Position pump housing on smooth flat surface

and install pump rotors.

NOTE: New rotors may be installed with either face

up. Used rotors must be installed as removed. Refer to

reference chalk marks made during disassembly.

(2) Align and install reaction shaft support on

pump housing and finger-tighten attaching bolt.

(3) Insert two Slide Hammers J-6585-1 and Bolts J-

7004-3. from back to front, into threaded reaction shaft

support holes (fig. 2C-58). Bolts should be threaded into

AUTOMATIC TRANSMISSION

Fig. 2C-57 Reaction Shaft Bushing Installation—Model 999

Fig. 2C-58 Installing Slide Hammer Bolts

support until ends of bolts are 1/16-inch (1.6 mm) below

front machined surface of pump housing.

(4) Install one Pilot Stud Tool J-3387-2 into case

pump opening (fig. 2C-59).

Troubleshooting