Jeep J-10 Series 1982 Technical & Service Manual page 1065

(1) Remove bumper rail as described above.
(2) Position replacement bumper rail on work
bench and secure.
(3) Position horizontal bumper guards on bumper
rail and mark hole locations on bumper rail
(4) Center punch and drill 1/2-inch holes at marked
locations.
(5) Position horizontal bumper guards on bumper
rail and install screws attaching bumper guards to
bumper rail.
NOTE: SomefiUng ofholes may be required for proper
fit
(6) Position vertical bumper guards on bumper rail
at desired locations and mark hole location on bumper
rail.
(7) Center punch and drill 3/8-inch holes at marked
locations.
(8) Position vertical bumper guards on bumper rail
and install screws attaching bumper guards to bumper
rail.
NOTE: SomefiUng ofholes may be required for proper
fit.
(9) Install bumper rail as described above.
REAR BUMPERS
CJ Models
Renevtl
(1) Remove nuts and bolts attaching rear bump
erettes (fig. 3F-20) to vehicle frame.
BRACKET
BODY AND FRAME COMPONENTS 3F-15
BUMPERETTE
80430
Fl|. 3F-20 RearBaBptntte-CJPIoWs
(2) Remove rear bumperettes from vehicle frame.
lesttJlatlea
(1) Position rear bumperettes on vehicle frame.
(2) Install bolts and nuts attaching rear bump
erettes to vehicle frame.
Cherokee-Wagoneer Models
Biaonl
(1) Remove bumper guards (fig. 3F-21) from
bumper rail, if equipped.
90178
Rg. 3F-21 BwB«p*--ttirt*e*Wagoa*8rilo4eU 90178