Control Switch - Jeep J-10 Series 1982 Technical & Service Manual

ACTUATOR ROD
SWITCH
WINDOW AND DOOR
LOCK CROSS HARNESS
ACTUATOR ROD
LATCH
DOORS 3J-17
BEZEL
SWITCH
LATCH
MOTOR
REGULATOR
WINDOW AND DOOR
LOCK HARNESS
8100?
Rg. 3J-6 Bectrically Operated Door Windows and Door Locks
(2) Turn ignition switch to On position. If lamp does
not light, yellow wire has an open circuit or ignition
switch is defective.
(3) Reconnect yellow wire to circuit breaker.
(4) Disconnect red wire from circuit breaker and
connect test lamp to circuit breaker terminal and
chassis ground. If lamp lights, circuit breaker is good. If
lamp does not light, circuit breaker is defective.
Control Switch and Motor Test
(1) Connect test lamp between terminals of yellow
and orange wire.
(2) Operate control switch up and down for respec
tive window. If lamp lights in Up and Down position,
test indicates that yellow and orange wires of wire har
ness to that window and back again to master switch are
not defective. It also indicates that individual door
switch on master control is not defective.
(3) Disconnect white and green motor leads at ter
minal plate and connect these leads to green and white
leads respectively.
(4) Operate master switeh. If window goes up and
down, motor is not defective but switch is defective. If
motor does not operate, remove door trim panel and
check connections and leads to motor. If motor operates,
switch is defective.
NOTE: It may be possible that switch and motor both
are defective.
CONTROL SWITCH
Removal
CAUTION: Be sure ignition switch is in Offposition.
(1) Disconnect battery negative cable.
(2) Remove retaining screws and escutcheon.
(3) Remove switch housing screws. Pull switch out
to expose wires.
(4) Disconnect terminal plate from switch.
(5) Depress retainer clips through holes in switch
housing and remove switch.
Installation
(1) Hold retainer clips in position on switch and
slide switch into housing. Press retainer clips until they
click into position.