Jeep J-10 Series 1982 Technical & Service Manual page 676

2D-2 TRANSFER CASE
four wheels on the ground or with front or rear wheels
raised. Turn front drive hubs to 4 x 4 or Lock position.
Turn ignition key to Off position to unlock steering
column.
Ignition Key Not Available and Vehicle is Un
locked: Shift transmission and transfer case into Neu
tral and tow vehicle with front wheels raised.
Ignition Key Not Available and Vehicle is
Locked: Place dolly under rear wheels and tow vehicle
with front end raised. Or, disconnect fear propeller
shaft at rear axle yoke (be sure to mark the shaft and
yoke for proper alignment at reassembly), secure shaft
to underside of vehicle, and tow with front end raised.
NOTE: On CJ and Scrambler models, when towing ve
hicle over 200 miles (300 km), stop towing every 200
miles (300 km). With the transfer case still in N (Neu
tral) and transmission in gear, start engine and rev
engine for about one minute to circulate oil in the trans
fer case. .. . ,. %: -„.. .... . . .
Towing Vehicle with Automatic Transmission and Model 208 or300
Transfer Case
Ignition Key Available: Turn ignition key to Off posi
tion to unlock steering column and gearshift selector
linkage. Move gearshift lever to Park and transfer case
shift lever to Neutral.
Ignition Key Not Available: Place dolly under rear
wheels and tow vehicle with front end raised. Or, dis
connect rear propeller shaft at rear axle yoke (index
mark yoke for correct assembly), secure shaft to under
side of vehicle, and tow with front wheels raised.
NOTE: On CJ and Scrambler models, when towing ve
hicle over 200 miles (300 km), stop towing every 200
miles (300 km) and ivith the transfer case still in N
(Neutral), start engine, place automatic transmission in
D (Drive), and rev engine for about one minute to circu
late oil in the transfer case.
Towing Vehicle with Automatic Transmission and Model 219
Quadra-Trac Transfer Case
Igniti&n Key Available: Vehicle can be towed with all
four wheels on the ground without disconnecting prop
eller shafts. Turn ignition key to Off position to unlock
steering wheel. Move gearshift lever to Park and shift
transfer case shift lever to Neutral position.
Ignition Key Not Available: Place dolly under rear
wheels and tow vehicle with front wheels raised. Or,
disconnect rear propeller shaft at rear axle (mark yoke
for correct assembly), secure shaft to underside of ve
hicle, and tow with front wheels raised.
Recreational Towing
Jeep vehicles can be towed behind a recreational ve
hicle such as a motor home, but the following instruc
tions must be followed to avoid damaging drive line
components. Also be sure to check and comply with
federal, state and local laws or ordinances regarding this
type of towing.
With Manual Transmission and Model 208 or Model 300 Transfer
- (1) Turn ignition switch to Off position to unlock
steeringwheel. ^ -t %'
(2) Shift transmission into gear and the transfer
case into Neutral. -•"' " .••••.-. ,-:::;; .-.^
(3) Turn selective drive hubs to 4 x 4 or Lock posi
tion, for axle lubrication.
With Automatic Transmission and Model 208 or Model 300 Transfer
Case
(1) Turn ignition switch to Off. position to unlock
steering wheel.
' "(2) Shift automatic transmission into Park.
(3) Shift transfer case into Neutral position.
(4) Turn selective drive hubs to 4 x 4 or Lock posi
tion for axle lubrication.
With Automatic Transmission and Model 219 Quadra-Trac Transfer Cast
(1) Turn ignition switch to Off position to unlock
steering wheel. . • ". .; •
(2) Shift automatic transmission into Park.
(3) Shift transfer case into Neutral position.
Trailer Towing and Campers
The Jeep Corporation new vehicle warranty includes
conditions and limitations for vehicles used in towing
trailers or campers or installation of slide-in campers on
Jeep Trucks. The requirements and recommendationsin
this manual' and other factory literature must be fol
lowed in order to maintain this coverage.
In addition to the vehicle maintenance and servicing
requirements set forth in this manual, the GVW and
GAW ratings are of special significance. When a Jeep
vehicle is to be used for trailer or camper towing, or
slide-in camper installations in Jeep Trucks, it is ex
tremely important that the GVWor GAW ratings not be
exceeded by the addition of:
• The tongue weight of a trailer.
•The weight transferred to a Truck model by the
mounting of a fifth-wheel trailer.
• The weight of a slide-in camper or any other type of
truck camper.
• The weight of any other type of vehicle put in or on
the towing vehicle.
Remember that additional items placed in or on the
trailer or mounted camper will add to the load.