Lock System - Jeep J-10 Series 1982 Technical & Service Manual

3H-2 LIFTGATES—TAILGATES
RUBBER
SEALER
LATCH
GLASS
LIFTGATE
SUPPORT
CYLINDER
70509
Re.3H-1 Uftejtte CoetpOBeots
NOTE: Inspect for uneven surfaces or irregularities in
the opening flange that couldcause stress damage to the
glass.
(6) Before installing weatherstrip on glass, apply
3/16-inch bead of 3M Auto Bedding and Glazing Com
pound, or equivalent, in weatherstrip flange cavity us
ing pressure-type applicator.
(7) With glass installed in weatherstrip and before
installing glass and weatherstrip into opening, insert
1/4-inch cord completely around weatherstrip in flange
cavity.
NOTE: The ends of the cord should hang out over the
outside surface of the glass approximately in the center
of the upper weatherstrip.
(8) Place glass and weatherstrip into position in
window opening with ends of cord hanging outside
vehicle.
(9) Pull on ends of cord to pull lip of weatherstrip
over body panel. With cord removed, weatherstrip
should be positioned correctly.
(10) Use wooden wand to lockweatherstrip.
(11) Using pressure-type applicator, apply 3MWind
shield Sealer, or equivalent, between weatherstrip and
glass on outside of glass around entire perimeter.
(12) Clean excess sealer from glass and exterior body
surface.
(13) Test window for water leaks.
LOCK SYSTEM
Outside Hindis Replacement
(1) Remove screws attaching remote control to lift
gate using Torx Bit Tool J-25359-C.