Jeep J-10 Series 1982 Technical & Service Manual page 1202

3T-18 WINDSHIELD WIPERS
•I
*
~
~
~
11.
SHAFT
22. END HEAD
—
1.
NUT
12.
SWITCH WASHER
23. ARMATURE
2. DRIVE CRANK 13. SWITCH LEVER
24. BALL
3. SEAL 14. OUTPUT GEAR AND SHAFT
25. MOTOR HOUSING
4.
BRACKET
15. END PLAY SPRING
26. BOLT • •
5. SCREW 16. IDLER GEAR AND PINION
27.
SCREW
6. GROUND STRAP
17. GASKET 28.
BRUSH
~
7. SPRING WASHER 18. SCREW 29.
SPRING
8. PLAIN WASHER 19. COVER 30.
PARKING LEVER PIN
—
9. GROMMET 20. PUSH NUT 31.
SCREW
10.
GEAR HOUSING 21.
BRUSHES AND HARNESS 32.
SEAL
41532
Rg. 3T-17 Wlior Motor aid TruMlssJon Coapoioits
(12) Install motor housing on armature, holding ar
mature worm gear to prevent magnetic field from pull
ing armature out of position in gear housing.
(13) Align indicator marks on motor housing and
gear housing before inserting through-bolts.
(14) Install through-bolts securing motor housing to
gear housing.
(15) Apply generous amount of lubricant to gear
housing cavity.
(16) Position gasket and cover on gear housing and
install two attaching screws.
(17) Position motor assembly and ground strap on
mounting bracket and install ground strap attaching
screw.