Honda NSX-T 1998 Manual page 1478

Main Menu
Sensor Inspection
CAUTION: Take extra care when painting or doing
body work on any part of the dashboard lower panel.
Avoid direct exposure of the sensors or wiring to heat
guns, welding, or spraying equipment.
• Disconnect both the negative and positive battery
cables.
• Install the short connectors before working around
the dashboard lower panel or the SRS sensors.
• After any degree of frontal body damage, inspect
both dash sensors. Replace a sensor if it is dented,
cracked, or deformed.
• Be sure the sensors are installed securely.
BRACKET
DASH
SENSOR
Table of Contents
DASHBOARD
LOWER PANEL
MOUNTING
BOLTS
Wiring Precautions
Never attempt to modify, splice or repair SRS wiring.
NOTE: SRS wiring can be identified by special
yellow outer protective covering.
• Be sure to install the harness wires so that they are
not pinched or interfering with other car parts.
• Make sure all SRS ground locations are clean and
grounds are securely fastened for optimum metal-
to-metal contact. Poor grounding can cause inter-
mittent problems that are difficult to diagnose.