Seat Belt; Short Connector (Red) - Honda NSX-T 1998 Manual

Main Menu
Airbag/Seat Belt Tensioner Disposal
Before scrapping any airbags or seat belt tensioners
(including those in a whole car to be scrapped), the
airbags must be deployed and the seat belt tensioners
must be triggered. If the car is still within the warranty
period, before deploying the airbag(s) or triggering the
seat belt t e n s i o n e r s , the A c u r a District T e c h n i c a l
Manager must give approval and/or special instruction.
Only after the airbags are already deployed or the seat
belt tensioners are triggered (as the result of vehicle col-
lision, for example), can the normal scrapping proce-
dure be done.
If the airbags or the seat belt tensioners appear intact
(not deployed or triggered), treat them with extreme
caution.
Follow the procedure, described below.
Deploying the Airbag(s): In-vehicle
NOTE: If an SRS vehicle is to be entirely scrapped,
its airbags should be deployed while still in the
vehicle. The airbags should not be considered as
salvageable parts and should never be installed in
another vehicle.
Confirm that each airbag assembly is
securely mounted; otherwise, severe personal in-
jury could result from deployment.
1. Disconnect both the negative cable and positive
cable from the battery.
2. Confirm that the special tool is functioning properly
by following the check procedure on the label of
the tool or on page 24-41.
Driver's Airbag:
3. Remove the access panel, then disconnect the 3P
connector between the airbag and the cable reel.
DRIVER'S
AIRBAG 3P
CONNECTOR
ACCESS PANEL
Table of Contents
DRIVER'S AIRBAG
ASSEMBLY
CABLE REEL 3P
CONNECTOR
SHORT CONNECTOR
(RED)
Passenger's Airbag:
4. Remove the glove box, then disconnect the con-
nector between the passenger's airbag and SRS
main harness.
PASSENGER'S
AIRBAG
3P CONNECTOR
5. Cut off the driver's airbag connector, then strip the
wire ends and connect the special tool alligator
clips to them. Place the special tool approximately
thirty feet away from the airbag.
DRIVER'S AIRBAG
ASSEMBLY
ALLIGATOR
CLIPS
(YELLOW)
OPERATION
SWITCH
DEPLOYMENT
TOOL
07HAZ - SG00400
PASSENGER'S AIRBAG
ASSEMBLY
SRS MAIN
HARNESS
PASSENGER'S AIRBAG
ASSEMBLY
ALLIGATOR
CLIPS
(YELLOW)
12 VOLT BATTERY