Table of Contents
Advertisement
Main Menu
9.
Remove the protective tape from the door, and
carefully scrape the adhesive tape from the door
and door lower trim with a plastic putty knife.
10. Clean the bonding surface with a sponge dampened
in alcohol.
NOTE: Make sure the bonding surface is kept free of
water, oil and grease.
11. Apply primer (3M N-200, or equivalent) to the door
lower trim where new adhesive tape will be applied.
12. Glue the new adhesive tape (3M 4211, or equiva-
lent) to the door lower trim as shown.
13. Set the clips on the door lower trim.
NOTE: Apply liquid thread lock to the front bolt and
rear bolt.
Table of Contents
14. If the adhesive tape is replaced, fold the adhesive
backing of the adhesive tape. Hold the trim up, and
fit all the clips into the holes in the door, then push
on the trim until the clips snap into place.
15. Carefully pull the adhesive backing away, then
press the adhesive tape portions to make the adhe-
sive stick.
16. Install the special nuts and screws.
17. Reinstall all removed parts.
Advertisement
Chapters
Table of Contents
