Avaya Definity SI Maintenance Manual page 1847

MAPD-BD (MAPD Interface Circuit Pack TN802)
Control Channel Looparound Test (#52)
This test queries the circuit pack for its circuit pack code and vintage and verifies
its records.
Table 10-386. TEST #52 Control Channel Looparound Test
Error
Code
None ABORT
2100
FAIL
PASS
0 NO
BOARD
555-233-123
Test
Result
System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5
times.
The circuit pack failed to return the circuit pack code or vintage.
1. Retry the command a maximum of 5 times.
2. If the problem continues, and if the circuit pack is one of the
Port circuit packs, replace the circuit pack.
3. Otherwise, if the circuit pack is part of the SPE, use the
procedure described in Replacing SPE Circuit Packs in
Chapter 5.
Communication with this circuit pack is successful.
The test could not relate the internal ID to the port (no board).
This could be due to incorrect translations, no board is inserted,
an incorrect board is inserted, or an insane board is inserted.
1. Ensure that the board translations are correct. Execute add
ds1 UUCSS to administer the MAPD interface if it is not
already administered.
2. If the board was already administered correctly, check the
error log to determine whether the board is hyperactive. If
this is the case, the board is shut down. Reseating the board
re-initializes the board.
3. If the board was found to be correctly inserted in step 1, then
issue busyout board.
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the linkage between the internal ID and
the port.
Description/Recommendation
Continued on next page
Issue 4 May 2002 10-1061