Reusing A Tn2312Ap Circuit Pack; Administering The Static Ip Address - Avaya S8700 Installing Manual

Installing the Avaya™ S8700 Media Server with Avaya™ G600 Media Gateway
Connecting directly to the IPSI
1
cadlipsi KLC 031502
Figure notes
1 Services laptop
PCMCIA Network Interface Card (NIC)
2

Reusing a TN2312AP circuit pack

!
CAUTION:
If reusing TN2312AP circuit packs that have previously had a static address programmed,
you must erase the existing IP address before programming another one. Failure to do this
may result in serious network problems for the customer. Use the following procedure to
erase an existing IP address assignment:
1 Plug the TN2312 into the appropriate slot in the media gateway or if already plugged in,
reseat it (unplug and plug in).
While the letters I P are flashing on the LED display (5 seconds), press the recessed
2
pushbutton on the faceplate.
The TN2312 is now ready for a new static IP address.
3

Administering the static IP address

NOTE:
Make sure you have the password before proceeding. Refer to the filled-out job aid
entitled Pre-Installation Network Planning Forms—S8700 Media Server for more
information.
2
3
3 NIC adapter cable (if necessary)
CAT5 crossover cable to IPSI
4
May 2003
Connecting to the IPSIs
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
4
151