Oil Change - Suzuki GA413 Service Manual

7F-4 DIFFERENTIAL
Viscosity chart SAE
ON-VEHICLE SERVICE

OIL CHANGE

1) Remove oil drain plug and drain oil.
2) Reinstall drain plug and tighten it to specified tightening torque.
Tightening Torque
(a): 55 N·m (5.5 kg-m, 40.0 lb-ft)
3) Remove oil level & filler plug and fill differential housing with new
specified oil.
About 1.3 liter of gear oil is required to fill up differential housing.
Differential oil specification
Hypoid gear oil API GL-5
SAE 80W-90 or 75W-85
Oil capacity:
1.3 liters (2.8/2.3 US/Imp pt.)
NOTE:
D Hypoid gear oil must be used for differential.
D It is highly recommended to use SAE 80W-90 viscosity.
4) Install level/filler plug and torque it to specification.
Tightening Torque
(b): 50 N·m (5.0 kg-m, 36.5 lb-ft)
REMOVAL
1) With vehicle rested steady on safety stands, draw out right and
left rear axle shafts referring to "Rear axle shaft removal" in
"REAR SUSPENSION" section of this manual.
2) At differential housing, disconnect propeller shaft by removing
bolts securing flange yoke to companion flange. Refer to "Pro-
peller Shafts" section. Remove differential assembly by remov-
ing its 10 fastening bolts.