Suzuki GA413 Service Manual page 191

3F-6 WHEELS AND TIRES
ON-VEHICLE SERVICE
WHEEL
REMOVAL
1) Loosen wheel nuts by approximately 180_ (half a rotation).
2) Hoist vehicle.
3) Remove wheel.
NOTE:
Never use heat to loosen tight wheel because application
of heat to wheel can shorten life of wheel and damage
wheel bearings.
INSTALLATION
Wheel nuts must be tightened in sequence and to proper torque to
avoid bending wheel or brake drum or disc as in figure.
NOTE:
Before installing wheels, remove any build-up of corrosion on
wheel mounting surface and brake drum or disc mounting
surface by scraping and wire brushing. Installing wheels with-
out good metal-to-metal contact at mounting surfaces can
cause wheel nuts to loosen, which can later allow wheel to
come off while vehicle is moving.
Tightening Torque
.
(a): 85 N m (8.5 kg-m, 61.5 lb-ft)