Suzuki GA413 Service Manual page 195

1. Match mark
2. Propeller shaft
3. Joint flange
ON-VEHICLE SERVICE
REMOVAL
1) Hoist vehicle.
2) Drain transmission oil.
3) Before removing propeller shaft, give match marks on each joint
flange and propeller shaft as shown.
4) Loosen propeller shaft bolts.
5) Remove propeller shaft.
INSPECTION
Inspect propeller shaft and flange yoke for damage, and propeller
shaft for runout.
If damage is found or shaft runout exceeds its limit, replace.
Runout limit: 0.7 mm (0.028 in.)
INSTALLATION
Install propeller shaft reversing removal procedure noting following
points:
D When installing propeller shaft, align the match marks.
Otherwise, vibration may occur during driving.
D Use following specification to torque universal joint flange.
Tightening Torque
(a): 23 N·m (2.3 kg-m, 16.6 lb-ft)
D Apply grease to spline part of propeller shaft and transmission
output shaft.
NOTE:
If transmission oil was drained for propeller shaft removal,
pour specified gear oil into transmission case to specified lev-
el.
PROPELLER SHAFT 4B-3