Suzuki GA413 Service Manual page 1050

ITEM 6-4
Brake Fluid
Inspection
1) Check around master cylinder and reservoir for fluid leakage.
2) Check fluid level.
1. Reservoir tank
2. Maximum level mark
3. Minimum level mark
Change
Change brake fluid as follows.
Drain existing fluid from brake system completely, fill system with
above recommended fluid and carry out air purge operation.
For air purging procedure, refer to BLEEDING BRAKES in SEC-
TION 5.
ITEM 6-5
Parking Brake Lever and Cable
Parking brake lever inspection
1) Check tooth tip of each notch for damage or wear. If any damage
2) Check parking brake lever for proper operation and stroke, and
MAINTENANCE AND LUBRICATION (4WD) 0B1-15
If found leaky, correct.
If fluid level is lower than the minimum level of reservoir, refilling
is necessary. Fill reservoir with specified brake fluid indicated on
reservoir cap.
For the details, refer to BRAKE FLUID LEVEL CHECK in SEC-
TION 5.
CAUTION:
Since brake system of this vehicle is factory-filled with
glycol-base brake fluid, do not use or mix different type
of fluid when refilling system; otherwise serious damage
will occur. Do not use old or used brake fluid, or one taken
from unsealed container.
or wear is found, replace parking lever.
adjust it if necessary.
For checking and adjusting procedures, refer to PARKING
BRAKE CHECK AND ADJUSTMENT in SECTION 5.
"a": Parking brake lever stroke: 4 – 7 notches (with 20 kg
(44 lbs) of pull pressure)