Suzuki GA413 Service Manual page 585

7F-2 DIFFERENTIAL
The components of the differential are shown in figure below. The bevel gear drive is of hypoid design; pinion and
gear have hypoid gear teeth. This means that the pinion is located slightly below the center of the bevel gear to
permit the car body to be lowered in design, and that some wiping or sliding action occurs in tooth meshing between
pinion and gear. Here lies the reason why use of hypoid gear oil is specified for the differential.
GENERAL DESCRIPTION
1. Bevel gear & pinion set
2. Differential case
3. Side bearing
4. Bearing adjuster
5. Differential gear set
6. Thrust washer
7. Side pinion shaft
8. Thrust washer
9. Rear bearing
10. Shim
11. Spacer
12. Differential carrier set
13. Front bearing
14. Oil seal