Suzuki GA413 Service Manual page 332

6A-26 ENGINE MECHANICAL
6) Install timing belt, tensioner, oil pump strainer, oil pan and oth-
er parts as previously outlined.
7) Check to ensure that all removed parts are back in place. Rein-
stall any necessary parts which have not been reinstalled.
8) Adjust generator drive belt (water pump drive belt) tension, re-
ferring to BELT TENSION INSPECTION in Section 6H.
9) Adjust A/C compressor belt tension, if equipped. Refer to Sec-
tion 0B.
10) Refill engine with engine oil, referring to item ENGINE OIL
CHANGE in Section 0B.
11) Refill cooling system and bleed air from system, referring to
Section 6B.
12) Connect negative cable at battery.
13) Verify that there is no coolant leakage and each oil leakage at
each connection.
14) After completing installation, check oil pressure by running en-
gine.