Suzuki GA413 Service Manual page 598

1. Brush
A: Paint gear marking compound evenly
1. Caulking tool
2. Flange nut
7) Torque bearing cap bolts to specification and install bearing lock
plates. Apply thread lock cement to bearing lock plate bolt.
Tightening Torque
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
(b): 11.5 N·m (1.15 kg-m, 8.5 lb-ft)
"A": Thread lock cement 99000-32050
8) As final step, check gear tooth contact as follows.
(1) After cleaning tooth surface of 10 bevel gears, paint them
with gear marking compound evenly by using brush or
sponge etc.
CAUTION:
When applying red lead paste to teeth, be sure to
paint tooth surfaces uniformly. The paste must not
be too dry or too fluid.
(2) Turn gear to bring its painted part in mesh with bevel pinion
and turn it back and forth by hand to repeat their contact.
(3) Bring painted part up and check contact pattern, referring to
following chart (next page). If contact pattern is not normal,
readjust or replace as necessary according to instruction in
chart.
NOTE:
Be careful not to turn bevel gear more than one full revo-
lution, for it will hinder accurate check.
9) Upon completion of gear tooth contact check in step 8, caulk
flange nut with caulking tool and hammer.
DIFFERENTIAL 7F-15