Suzuki GA413 Service Manual page 238

5-42 BRAKES
1. Brake back plate
2. Brake pipe flare nut
3. Brake pipe
4. Wheel cylinder bolts
4) Remove wheel cylinder mounting bolts. Disconnect brake pipe
from wheel cylinder and put bleeder plug cap onto pipe to pre-
vent fluid from spilling.
1. Bleeder plug cap
INSPECTION
Inspect wheel cylinder disassembled parts for wear, cracks, corro-
sion or damage.
NOTE:
Clean wheel cylinder components with brake fluid.
INSTALLATION
1) Apply sealant to wheel cylinder. Then take off bleeder plug cap
from brake pipe and connect pipe to wheel cylinder just enough
to prevent fluid from leaking.
"A": Sealant 99000-31090
2) Tighten wheel cylinder to brake back plate to specified torque.
Tightening Torque
(a): 9 N·m (0.9 kg-m, 6.5 lb-ft)
3) Torque flare nut of brake pipe which was connected in step 1)
to specification.
Tightening Torque
(b): 16 N·m (1.6 kg-m, 12.0 lb-ft)
4) Install bleeder plug cap taken off from pipe back to bleeder plug.