Suzuki GA413 Service Manual page 776

5-4 BRAKES
BRAKE PAD
INSTALLATION
For the details, refer to the same item of the same section in service
manual mentioned in FOREWORD of this manual noting the fol-
lowing.
NOTE:
See NOTE at the beginning of this section.
Install shims to pads, then pad clips and pads to caliper carrier.
NOTE:
D In case of using a pad set including two brake pads with
wear gauge, install the pads with wear gauge to body center
side of caliper carrier, right and left respectively.
D In case of using a pad set including one brake pad with wear
gauge, install the pad with wear gauge to body center side
of right caliper carrier.
1. Clips
2. Pads
3. Wear gauge
4. Caliper carrier
BRAKE STOP LAMP
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect stop lamp switch connector.
3) Remove stop lamp switch from pedal bracket by turning it coun-
terclockwise and pulling.
INSTALLATION
1) Adjust stop lamp switch position to clearance "a" between end
of the switch and brake pedal, and turn the switch clockwise to
fasten it.
For clearance "a" specifications, refer to STOP LIGHT SWITCH
ADJUSTMENT in this section.
2) Connect stop lamp switch connector.
3) Connect negative cable at battery.