Suzuki GA413 Service Manual page 770

1. Coil spring
1. Strut support cap 9. Spring upper seat
2. Strut nut 10. Spring seat
3. Strut lock washer 11. Bump stopper
4. Strut rebound stopper 12. Coil spring
5. Strut support 13. Strut assembly
6. Strut rubber support
[A]: Conical coil spring type
7. Strut bearing seat
[B]: Cylindrical coil spring type
8. Strut bearing
ON-VEHICLE SERVICE
STRUT DAMPER ASSEMBLY
ASSEMBLY
For the details, refer to the same item of the same section in service
manual mentioned in FOREWORD of this manual noting the fol-
lowing points.
: Upper side D For cylindrical coil spring type, make sure that coil spring direc-
A: Small
tion as shown.
B: Large
D On bearing seat, install rebound stopper, strut support and rub-
ber support in this sequence. Refer to the figure for installing
directions. Tighten strut nut to specified torque and then apply
water-proof coating (paint or lacquer) all around nut and strut rod
screw part.
NOTE:
As shown at the left, have sections "A" and "B" of strut sup-
port rubber caught by strut support securely.
Tightening Torque
(a): 50 N·m (5.0 kg-m, 36.5 lb-ft)
FRONT SUSPENSION 3D-3