Suzuki GA413 Service Manual page 551

7A-12 MANUAL TRANSMISSION
4) Remove circlip retaining rear bearing (1) on main shaft. Re-
move main shaft bearing using special tool.
Special Tool:
(A): 09913-65135
5) From main shaft, take off 5th gear, 5th speed synchronizer ring
and 5th gear needle bearing.
6) Remove circlip retaining 5th speed synchronizer hub on main
shaft.
7) [In the case of press-fitting hub]
CAUTION:
Make sure to use flat side of puller to avoid causing
damage to reverse gear teeth.
Drive out 5th speed synchronizer sleeve and hub assembly (1)
together with reverse gear (2) by using puller (3) and hydraulic
press (4).
[In the case of loose-fitting hub]
Remove 5th speed synchronizer sleeve and hub assembly (1),
and reverse gear.
8) Take out reverse gear needle bearing from shaft.
9) Remove circlip and then bearing washer and ball. Pull out
main shaft (center) bearing by using puller (2) and hydraulic
press (1).
NOTE:
In the state as shown, there is a ball in washer which is lo-
cated under bearing. Be sure to prevent it from falling off
and getting lost.