Suzuki GA413 Service Manual page 739

Hide thumbs Also See for GA413:

PASSENGER AIR BAG (INFLATOR) MODULE (IF EQUIPPED)

D Never attempt to disassemble or repair the passenger air bag (inflator) module. If any abnormality

is found, be sure to replace it with new one as an assembly.

D Be sure to read SERVICE PRECAUTIONS in this section before starting to work and observe every

precaution during work. Neglecting them may result in personal injury or undeployment of the air

bag when necessary.

1. Glove box

2. Glove box circlip

3. Passenger air bag (inflator) module

4. Instrument panel

5. Harness cover

1) Disconnect negative cable at battery.

2) Open glove box, then while pressing glove box stopper, pull out

glove box from instrument panel and then remove glove box cir-

clip and glove box from instrument panel.

3) Disable air bag system. Refer to DISABLING AIR BAG SYS-

TEM of SERVICE PRECAUTIONS in this section.

4) Remove passenger air bag (inflator) module attaching bolts

and screws and passenger air bag (inflator) module from ve-

Never measure resistance of passenger air bag (inflator)

module or disassemble it. Otherwise personal injury may

If air bag (Inflator) module was dropped from a height or

90 cm (3 ft) or more, it should be replaced.

Check air bag (inflator) module appearance visually for following

symptoms and if any one of them is applicable, replace with a new

D Air bag has deployed.

D There is a crack in trim cover (pad surface).

D Wire harness or connector is damaged.

D Air bag (inflator) module is damaged or a strong impact (e.g.,

dropping) was applied to it.

AIR BAG SYSTEM 10B-45

Show Quick Links

Chapters