Suzuki GA413 Service Manual page 159

3D-14 FRONT SUSPENSION
INSTALLATION
1) Insert new stud in hub hole. Rotate stud slowly to assure serra-
1. Oil hydraulic press
2. Rod
3. Hub bolt
2) Install wheel hub to spindle, tighten new spindle nut to specified
3) Install brake disc.
4) Install brake caliper/caliper carrier.
5) Calk spindle nut as shown.
6) Install spindle cap to wheel hub.
7) Install wheel and lower hoist.
tions are aligned with those made by original bolt.
torque.
Tightening Torque
(a): 175 N·m (17.5 kg-m, 126.5 lb-ft)
Tighten caliper carrier bolts to specified torque.
Tightening Torque
(b): 95 N·m (9.5 kg-m, 69.0 lb-ft)
WARNING:
Be careful while calking nut so that no crack will occur
in calked part of nut. Cracked nut must be replaced
with new one.